PLP ADSS CORONA COIL .575-.687 NEW *ORDER MINIMUM* 50
Available*
Item # 30180834
Model # 506014245
$33.75
financing available. Learn More
* Notes on Availability:
(Images may not be of the actual item being sold.)
- Product Description
- You Might Also like
- Recently Viewed
Generic
Class
Group
Type
Manufacturer
LOT
DAMPERS
Material and Supplies
Hardware- Screws- Bolts
Clamps
Preformed Line Products
Warning: This product can expose you to chemicals, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.govProduct Description
PLP ADSS CORONA COIL .575-.687 NEW *ORDER MINIMUM* 50
PLP ADSS CORONA COIL .575-.687 NEW *ORDER MINIMUM* 50
PLP ADSS CORONA COIL .575-.687 NEW *ORDER MINIMUM* 50
The ADSS-CORONA Coil is intended to reduce electrical stress at the ends of the metal rods of FIBERLIGN® Dielectric Dead-Ends and Suspensions installed in high-voltage environments (areas where electrical lines are 115 kV and higher or areas where an electrical field analysis places the space potential of the ADSS cable above 12 kV).
Features Designed to suppress electrical arcing at the ends of metal rods Made from a lightweight material Designed to be used only with PLP's FIBERLIGN Dielectric Dead-Ends or Suspensions Quickly installed by hand or with a conventional hot stick Dead-end locations require one unit; suspension installations require two units
PLP ADSS CORONA COIL .575-.687 NEW *ORDER MINIMUM* 50
PLP ADSS CORONA COIL .575-.687 NEW *ORDER MINIMUM* 50
The ADSS-CORONA Coil is intended to reduce electrical stress at the ends of the metal rods of FIBERLIGN® Dielectric Dead-Ends and Suspensions installed in high-voltage environments (areas where electrical lines are 115 kV and higher or areas where an electrical field analysis places the space potential of the ADSS cable above 12 kV).
Features Designed to suppress electrical arcing at the ends of metal rods Made from a lightweight material Designed to be used only with PLP's FIBERLIGN Dielectric Dead-Ends or Suspensions Quickly installed by hand or with a conventional hot stick Dead-end locations require one unit; suspension installations require two units
