DCD 25000-010 Pulling Harness Single Leg - 9 inch
Available*
Item # 30512410
Model # 25000-010
$135.18
financing available. Learn More
* Notes on Availability:
(Images may not be of the actual item being sold.)
- Product Description
- You Might Also like
- Recently Viewed
Generic
Class
Group
Type
Manufacturer
LOT
GRIPS
Tools
Line Construction- Placing
Grips- Strand- Lashing Wire
DCD Design And Manufacturing Ltd
Warning: This product can expose you to chemicals, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.govProduct Description
DCD DESIGN/CABLE SPINNING EQUIPMENT 25000-010 Pulling Harness Single Leg - 9" NEW
The purpose of this product is to allow single or multiple pulls at one time by attaching 1 or 2 cables to the one pulling harness. The harness legs are manufactured from aircraft quality galvanized wire rope while the connector end is manufactured from stainless steel. The two leg units are staggered in length so the individual connections are not interfering with each other. The safety factor is based on equal pull on both legs. The double leg harness is available in long or short configurations and each is supplied with 1 hex key and 4 set screws. The single harness is supplied with 1 hex key and 2 set screws. Both the hex key and the set screws are available separately. Cable sizes that can be pulled with these harnesses are 2/0 to 4/0 AWG.
The purpose of this product is to allow single or multiple pulls at one time by attaching 1 or 2 cables to the one pulling harness. The harness legs are manufactured from aircraft quality galvanized wire rope while the connector end is manufactured from stainless steel. The two leg units are staggered in length so the individual connections are not interfering with each other. The safety factor is based on equal pull on both legs. The double leg harness is available in long or short configurations and each is supplied with 1 hex key and 4 set screws. The single harness is supplied with 1 hex key and 2 set screws. Both the hex key and the set screws are available separately. Cable sizes that can be pulled with these harnesses are 2/0 to 4/0 AWG.
