DCD 40010-250 Duct Guide Fabrication 2-1/2 inch
Available*
Item # 30514055
Model # 40010-250
$153.01
financing available. Learn More
* Notes on Availability:
(Images may not be of the actual item being sold.)
- Product Description
- You Might Also like
- Recently Viewed
Generic
Class
Group
Type
Manufacturer
LOT
PULLERS
Tools
Line Construction- Placing
Puller- Tuggers- Winches
DCD Design And Manufacturing Ltd
Puller Accessories
Warning: This product can expose you to chemicals, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.govProduct Description
DCD DESIGN/CABLE SPINNING EQUIPMENT 40010-250 Duct Guide Fabrication 2-1/2" NEW
The duct guides are designed to locate inside the ducting and provide an anchor point for the TUF-Lugger™ to pull against. Each TUF-Lugger™ is provided with the duct guides marked with an *. These and all other units are also available individually. Each duct guide has mounting holes for attachment to the last Sheave on the TUF-Lugger™. The assembly of the duct guide to the TUF-Lugger™ is reversed for upward direction as opposed to downward direction. Each unit also has a pair of holes used for indexing the position of the guide in increments of 7-1/2 degrees. All DCD DESIGN/CABLE SPINNING EQUIPMENT duct guides are open on one side to allow easy installation or removal without feeding over the cable or pulling rope.
The duct guides are designed to locate inside the ducting and provide an anchor point for the TUF-Lugger™ to pull against. Each TUF-Lugger™ is provided with the duct guides marked with an *. These and all other units are also available individually. Each duct guide has mounting holes for attachment to the last Sheave on the TUF-Lugger™. The assembly of the duct guide to the TUF-Lugger™ is reversed for upward direction as opposed to downward direction. Each unit also has a pair of holes used for indexing the position of the guide in increments of 7-1/2 degrees. All DCD DESIGN/CABLE SPINNING EQUIPMENT duct guides are open on one side to allow easy installation or removal without feeding over the cable or pulling rope.
