Jameson 16-14-500MM Duct Hunter Traceable Rodder, 1/4 in. x 500 ft , Metric, Marked
Available*
Item # 34551094
Model # 16-14-500MM
$1,767.83
financing available. Learn More
* Notes on Availability:
(Images may not be of the actual item being sold.)
- Product Description
- You Might Also like
- Recently Viewed
Generic
Class
Group
Type
Manufacturer
LOT
Rodders
Tools
Line Construction- Placing
Rodders- Duct
Jameson Corporation
Rodder 301 to 600 feet
Warning: This product can expose you to chemicals, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.govProduct Description
Jameson 16-14-500MM Duct Hunter Traceable Rodder, 1/4 in. x 500 ft , Metric, Marked
Jameson 16-14-500MM Duct Hunter Traceable Rodder, 1/4 in. x 500 ft , Metric, Marked
Jameson P/N 16-14-500MM Duct Hunter Rodder, 1/4 in. x 500 ft , Metric, Marked every 1 m
The Duct Hunter™ is a traceable duct rodder that offers a non-invasive solution for locating and mapping underground ducts and pipes. Save time by eliminating digging and trenching. The detectable fiberglass rod incorporates a copper trace wire that can be located at depths up to 10 feet. When used with a signal transmitter to energize the wire, an electromagnetic signal is then detected via hand-held receiver to trace the entire line. The Duct Hunter™ comes standard with a male end ferrule, pulling eye and accessory kit conveniently attached to the frame.
4 inch Bend Radius Locate sewer laterals to confirm no cross bore has occurred Locate ductile iron, plastic, tile or concrete pipe For use in conduit with an inside diameter between 1 and 2 inches Includes 500 ft. of 1/4-inch diameter traceable fiberglass rod marked every 5 ft. (Metric every 1m) Dimensions: 36.25 in. x 24 in. x 13 in.
Jameson 16-14-500MM Duct Hunter Traceable Rodder, 1/4 in. x 500 ft , Metric, Marked
Jameson P/N 16-14-500MM Duct Hunter Rodder, 1/4 in. x 500 ft , Metric, Marked every 1 m
The Duct Hunter™ is a traceable duct rodder that offers a non-invasive solution for locating and mapping underground ducts and pipes. Save time by eliminating digging and trenching. The detectable fiberglass rod incorporates a copper trace wire that can be located at depths up to 10 feet. When used with a signal transmitter to energize the wire, an electromagnetic signal is then detected via hand-held receiver to trace the entire line. The Duct Hunter™ comes standard with a male end ferrule, pulling eye and accessory kit conveniently attached to the frame.
4 inch Bend Radius Locate sewer laterals to confirm no cross bore has occurred Locate ductile iron, plastic, tile or concrete pipe For use in conduit with an inside diameter between 1 and 2 inches Includes 500 ft. of 1/4-inch diameter traceable fiberglass rod marked every 5 ft. (Metric every 1m) Dimensions: 36.25 in. x 24 in. x 13 in.
