FIBER PLUS DVT-S2 DIVOT BARE FIBER TESTER - ST SINGLEMODE
Available*
Item # 51111855
Model # DVT-S2
$325.00
financing available. Learn More
* Notes on Availability:
(Images may not be of the actual item being sold.)
- Product Description
- You Might Also like
- Recently Viewed
Generic
Class
Group
Type
Manufacturer
LOT
ADAPTER
Fiber Optic Products
OTDR- Power Meter- Light Source- Idenitifiers- VFL
Fiber Test Adapters
Fiber Plus International
Fiber Bare Fiber Adapater
Warning: This product can expose you to chemicals, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.govProduct Description
FIBER PLUS DVT-S2 DIVOT BARE FIBER TESTER - ST SINGLEMODE NEW
FIBER PLUS DVT-S2 DIVOT BARE FIBER TESTER - ST SINGLEMODE NEW
Part # DVT-S2 Divot® Bare Fiber Testing Device - ST Singlemode Singlemode 9/125: 1 Cable Package Includes: Case, Divot® module with patch cable, 2 OCC Cartridges, Vial of Clean-out Wire and Instruction Sheet
The Divot® Bare Fiber Adapter (Tester) accepts cleaved and non-cleaved fiber, requires only 3/4 inch of bare fiber exposed and has a typical insertion loss of less than 0.5 dB when using cleaved fiber. No messy gel applicators or reservoirs to fill. Simply strip your fiber and insert.
Designed to quickly connect to unterminated (bare fiber) for testing, servicing or communication requirements. The Divot® device is ready to use right out of the box. All you have to do is connect the patch cable to your test equipment and insert bare fiber into the end of the Divot® module. Preparation of the bare fiber is easy. Simply strip and clean a few inches of fiber down to 125uM cladding, leaving approximately 3/4” of bare fiber exposed. Insert the bare fiber into the Divot® module until it stops. Connections are suitable for many testing applications with results similar to a standard terminated piece of fiber.
FIBER PLUS DVT-S2 DIVOT BARE FIBER TESTER - ST SINGLEMODE NEW
Part # DVT-S2 Divot® Bare Fiber Testing Device - ST Singlemode Singlemode 9/125: 1 Cable Package Includes: Case, Divot® module with patch cable, 2 OCC Cartridges, Vial of Clean-out Wire and Instruction Sheet
The Divot® Bare Fiber Adapter (Tester) accepts cleaved and non-cleaved fiber, requires only 3/4 inch of bare fiber exposed and has a typical insertion loss of less than 0.5 dB when using cleaved fiber. No messy gel applicators or reservoirs to fill. Simply strip your fiber and insert.
Designed to quickly connect to unterminated (bare fiber) for testing, servicing or communication requirements. The Divot® device is ready to use right out of the box. All you have to do is connect the patch cable to your test equipment and insert bare fiber into the end of the Divot® module. Preparation of the bare fiber is easy. Simply strip and clean a few inches of fiber down to 125uM cladding, leaving approximately 3/4” of bare fiber exposed. Insert the bare fiber into the Divot® module until it stops. Connections are suitable for many testing applications with results similar to a standard terminated piece of fiber.
