UNIWELD G75 LO PRESSURE GAUGE AIR PRESSURE GAUGE
Available*
Item # 25682000
Model # 54620
$17.77
financing available. Learn More
* Notes on Availability:
(Images may not be of the actual item being sold.)
- Product Description
- You Might Also like
- Recently Viewed
Generic
Class
Group
Type
Manufacturer
LOT
REGULATORS
Tools
Air Pressure
Regulators- Air Pressure
Uniweld Products Inc
Warning: This product can expose you to chemicals, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.govProduct Description
UNIWELD G75 LO PRESSURE GAUGE AIR PRESSURE GAUGE
UNIWELD G75 LO PRESSURE GAUGE AIR PRESSURE GAUGE
UNIWELD P/N G75 LO PRESSURE GAUGE AIR PRESSURE GAUGE
Pressure Calibration 30 PSI Case Type Brass Case B.M. (Bottom Mount) Gauge Size 2.5 inch ( 1/4 inch NPT**)
Oxygen cleaned welding gauges (cleaned for oxy per ANSI B40.1) suitable for use with oxygen, other fuel gases and medical equipment (that is non corrosive to brass or bronze) and where stem mounting is desired. Quality brass and steel case construction with one piece polycarbonate lens. Recommended for use with compressed gas regulators. Most 1-1/2 welding gauges are fitted with a protective rubber gauge boot.
B.M.= Bottom Mount | C.B.M.+ Center Back Mount * With Gauge Boot ** For 1/8" NPT add [-4] to Part # For non-display card packaging remove (D) from the part number.
UNIWELD G75 LO PRESSURE GAUGE AIR PRESSURE GAUGE
UNIWELD P/N G75 LO PRESSURE GAUGE AIR PRESSURE GAUGE
Pressure Calibration 30 PSI Case Type Brass Case B.M. (Bottom Mount) Gauge Size 2.5 inch ( 1/4 inch NPT**)
Oxygen cleaned welding gauges (cleaned for oxy per ANSI B40.1) suitable for use with oxygen, other fuel gases and medical equipment (that is non corrosive to brass or bronze) and where stem mounting is desired. Quality brass and steel case construction with one piece polycarbonate lens. Recommended for use with compressed gas regulators. Most 1-1/2 welding gauges are fitted with a protective rubber gauge boot.
B.M.= Bottom Mount | C.B.M.+ Center Back Mount * With Gauge Boot ** For 1/8" NPT add [-4] to Part # For non-display card packaging remove (D) from the part number.
